Oct 6, 2026Updated Oct 28, 20262 min read

How to calculate your real fuel consumption

By DriveMarker

The short answer

Fill up, note the odometer. Fill up again and note the litres and the distance between the two fills. Consumption = litres ÷ kilometres × 100 — that is the whole method.

Published fuel economy figures are test-cycle numbers. What your car actually drinks is whatever your own tank says — and the method below is the same one DriveMarker uses internally, so the number in your garage matches the number you can verify with a pen and paper.

The full-tank method

  1. Fill up until the pump clicks off (or the charge finishes — this works for EVs too, with kWh instead of litres).
  2. Note your odometer reading.
  3. At the next full fill, note the litres added and the new odometer reading.
  4. Work it out:
L/100km = litres of the latest fill ÷ (new odometer − previous odometer) × 100

Worked example: odometer goes from 10 000 to 10 500 km, and the latest full fill was 35 litres → 35 ÷ 500 × 100 = 7.0 L/100km.

Partial fills do not create a reading — they wait for the next full fill, because only a full-to-full pair tells you exactly how much fuel covered exactly that distance.

Converting the other direction

  • MPG (US) = 235.215 ÷ (L/100km). A 7 L/100km car is 235.215 ÷ 7 ≈ 33.6 MPG.
  • Litres for a trip = distance × L/100km ÷ 100. For 500 km at 7 L/100km that is 35 litres.
  • Cost = litres × your price per litre — or let the fuel cost calculator do all three steps at once.

Charging works the same way

For an EV, substitute kWh for litres: charge to full, note the odometer, charge to full again later, and use the kWh added against the distance driven. DriveMarker tracks kWh/100km the same full-to-full way — never mixing energy and fuel units.

Sanity-check the result

Most passenger cars land somewhere between 2 and 40 L/100km. A figure outside that range usually means a missed fill (a partial fill slipped into the maths), a typo in the odometer entry, or comparing two very different stretches of road — not that the car suddenly changed. Correct the logs and the number settles back down.

From consumption to cost

Consumption is only half the answer. To turn it into money:

Cost per 100 km = L/100km × price per litre

At 7.0 L/100km and $1.60 a litre, that is $11.20 per 100 km, or about 11.2¢ a kilometre. In miles, a 33.6 mpg car at $4.00 a gallon costs about 11.9¢ a mile. The cost-per-mile formula guide takes the same numbers through the full ownership calculation, and the fuel cost calculator does the arithmetic for a specific trip.

A note on winter and short trips

The same car can post very different numbers across the year. Cold starts, short trips, winter fuel blends and extra idling all raise consumption, sometimes by 20% or more in freezing weather. That is not a fault — it is the test cycle versus your actual routine. Compare like with like: a January figure against a January figure, not against a July best.

Common questions

How is fuel consumption calculated?
With two full fill-ups: divide the litres of the later fill by the kilometres driven since the earlier full fill, then multiply by 100. If you drove 500 km on 35 litres, that is 35 ÷ 500 × 100 = 7.0 L/100km.
How do I convert L/100km to MPG?
Divide 235.215 by the L/100km figure — that gives MPG in US gallons, the unit most online calculators use. A car at 7 L/100km is at about 33.6 MPG.
Why do partial fills mess up the number?
The method assumes the tank was full at both readings, so every litre you add is accounted for against a known distance. A partial fill breaks that link: the litres do not line up with the tank's true level, and the result drifts until the next full fill resets it.

Use the tools from this guide

Track your own numbers

Averages describe somebody else’s car. Log your fill-ups, costs and service in a free garage and the guide above turns into your own data.

Essential cookies run DriveMarker. With your permission, privacy-friendly analytics and advertising cookies do too. Cookie policy.